MK MK-100 - Flow Adjustment

31
MK-100 MAINTENANCE
Monthly Maintenance Cont.
(G)
Remove the Blade Guard.
Lubricate the Blade Guard
Pivot Shaft.
(H)
Remove the Cutting Head (Cut-
ting Head Adjustment pg 25).
(I)
Lubricate the threads on the
Cutting Head Adjustment
Knob.
(J)
Lubricate the Cutting Head
Adjustment Knob
retaining holes.
(K)
Lubricate the Cutting Head
Pivot Shaft.
If flow to the diamond blade requires adjustment, perform the following actions.
Flow Adjustment
(A)
Increase cooling ow
by releasing the Flow
Adjusting Clamp.
(B)
Reduce cooling ow by
pressing down on the Flow
Adjusting Clamp.
NOTE: