MK-101 w/JCS Stand Revision 04/05, Effective Date August 19, 2005
Page 9
SAFETY
SAFETY LABEL LOCATIONS:
Safety labels are located according to Figures 1 through 4 below. The labels contain important safety information.
Please read the information contained on each safety label. These labels are considered a permanent part of your saw. If
a label comes off or becomes hard to read, contact MK Diamond or your dealer for a replacement
Item Location Description Part No.
1. Motor Front Warning Read and Follow Operating Instructions 155806
1B. Motor Side Label, Caution, GFCI, 1 X 2 1/8 155678
2. Blade Side Saw Serial Number Specifications 157500
3. Motor Rear Service or Warranty Information 155038
4A Motor Rear Extension Cord Warnings 155672
4B Motor Rear Label, Caution, 5 Amp Max., 1 X 2-1/8 154822
4C Motor Rear Motor Specifications N/A
5A Pump Left Side Warning Connect to Grounded Receptacle N/A
5B Pump Right Side Pump Specifications N/A
TILE SAW SPECIFIC WARNINGS:
Wear eye protection.
Disconnect saw before servicing, when changing cutting blades, and cleaning.
Use tool only with smooth edge cutting blades free of openings and grooves.
Replace damaged cutting blade before operating.
4
A
B
3
1
A
B
2
A C
4
B
To Next Page
Loading...
