MKS Baratron 628A - Page 7

List of Fi
g
ures and Tables
v
List of Figures and Tables
Figures
Figure 1: Preferred Method To Connect an Overall Metal Braided Shielded Cable................ 22
Figure 2: Alternate Method To Connect an Overall Metal Braided Shielded Cable................ 22
Figure 3: Metal Single and Double Ferrule Compression-type Vacuum Fittings.................... 24
Figure 4: Location of the Zero Pot on Transducer Endcaps.................................................... 26
Figure 5: Location of the COARSE ZERO Adjustment Control ............................................ 27
Figure 6: Dimensions of the Types 622, 626, 627, 628, and 629 Transducers ........................ 29
Figure 7: Power, Signal, and Chassis Grounding Scheme...................................................... 30
Figure 8: Using Pin 7 as an External Zero Adjustment........................................................... 37
Figure 9: Type 629 Transducers Connected to Reject Common Mode Voltages .................... 38
Tables
Table 1: Definition of Symbols Found on the Unit .....................................................................2
Tabelle 2: Bedeutung der am Gerät angebrachten Symbole.........................................................6
Tableau 3: Définition des symboles apparaissant sur l'unité......................................................10
Tabla 4: Definición de los símbolos hallados en la unidad.........................................................14
Table 5: Interface Cables..........................................................................................................20
Table 6: Highest Pressure Suggested for Proper Zero Adjustment.............................................26
Table 7: Required Inputs for Types 622, 626, 627, 628, and 629 Transducers...........................30
Table 8: Pinout of Type 622 Transducer...................................................................................31
Table 9: Pinout of Types 626, 627, and 628 Transducers..........................................................31
Table 10: Pinout of Type 629 Transducer.................................................................................32
Table 11: Suggested Pressures for Reading and Control ...........................................................36
Table 12: Troubleshooting Chart..............................................................................................40