S13, S24, S28, S32 Troubleshooting
9
7 Troubleshooting
8 Disposal
➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the device, ask your local recycling
centre or specialist dealer for details about how to do this in accord-
ance with the applicable disposal regulations.
Fault Possible cause Suggested remedy
Your cooler does not
function (plug is
inserted).
There is no voltage flowing
from the 12 V socket (ciga-
rette lighter) in your vehicle.
The ignition must be switched on in
most vehicles for voltage to flow at the
cigarette lighter.
No voltage present at the
AC voltage socket
(S28 DC/AC, S32 DC/AC
only
).
Try using another plug socket.
Your cooler does not
cool (plug is inserted).
The inner fan or the cooling
element is defective.
This can only be repaired by an author-
ised customer services unit.
Operation with a 12 V
socket (cigarette
lighter):
The ignition is on and
the cooler is not work-
ing.
Pull the plug out of
the socket and make
the following checks.
The cigarette lighter socket
is dirty. This results in a
poor electrical contact.
If the plug of your cooler becomes very
warm in the cigarette lighter socket,
either the socket must be cleaned or the
plug has not been assembled correctly.
The fuse of the 12 V plug
has blown.
Replace the fuse (5 A) in the 12 V plug
(fig. 3 1, page 3).
The vehicle fuse has
blown.
Replace the vehicle's 12 V socket fuse
(usually 15 A). (Please refer to the oper-
ating manual of your vehicle.)
_S13_S24_S28_S32.book Seite 9 Mittwoch, 7. Mai 2008 2:07 14
To Next Page
Loading...
Need help?
General
