[Notice]:
• After use this command to awaken the printer, it needs at least 20
milliseconds to send data to printer, otherwise printer may print wrong
data.
•
If printer is not in standby mode when received this command, the
command would be ignored.
•
We suggest users to send this command before print data at anytime.
•
After the printer awakened, the printing commands are according with
the commands before the printer standby.
4.1.3 FF
[Name]: Print and return to standard mode in page mode
[Format]: ASCII FF
Hexadecimal 0C
Decimal 12
[Description]:
Prints the data in the print buffer collectively and returns to standard mode.
[Notes]:
• The buffer data is deleted after being printed.
• The printing area set by ESC W is reset to the default setting.
• This command sets the print position to the beginning of the line.
• If the printer is in black mark mode, the printer will feed line to the
position of black mark after the buffer data printed. If there isn’t black
mark, the printer will feed line 30cm then stop.
• If the printer is not in black mark mode, it will only pint buffer data,
won’t feed line.
[Reference]: LF, CR, ESC d, ESC J
4.1.4 LF
[Name]: Print and feed line
[Format]: ASCII LF
Hexadecimal 0A
Decimal 10
[Description]: Prints the data in the print buffer and feeds one line based on
the current line spacing.
[Notice]: This command sets the print position to the beginning of the line.
4.1.5 CR
[Name]: Print and carriage return
[Format]: ASCII CR
To Next Page
Loading...