MobiPrint MP T3 - Environmental Conditions; Other Features; Operation; Using Preparation

６
● Paper roll diameter:
≤40mm
● Interface: Bluetooth(only for TⅢBT model),
IrCOMM (only for T
Ⅲ
Ir
model), Raw-Ir (9600bps ～ 115200bps) (only for T Ⅲ Ra model),
RS232 serial (1200bps～115200bps)
2.3 Environmental Conditions
● Operation temperature: 5
～
45
℃
Relative humidity: 20%
～
85%
● Storage temperature: -20～70℃
Relative humidity: 5%～95%
2.4 Other Features
● Paper loading method: drop-in easy loading (details please refer to
3.1.2 Paper Installation).
● Black mark localization: available (details please see 4.2 ready printing
black mark specification).
● Paper out detection: when paper is out, the Mode indicator blinks, and
the buzzer rings twice.
● Print commands: ESC/POS compatible command set (refer to Chapter
4).
● Power supply: 1500mAh rechargeable polymer lithium battery.
● Low power alarm: when the battery is low, the power indicator blinks
with red color and the buzzer rings 3 times; if the printer is in sleeping
mode, the printer will cut off power after the buzzer rings 3 times.
● Sleeping: the printer will fall after at least 2 seconds without usage into
sleep, and can be awaken by pressing【FEED】button or sending data
to it.
● Battery full charge time: 3 hours.
● Battery duration: under 25% print density, at least 100 meters, the
standby time is over 15 days.
Chapter 3 Operation
3.1 Using Preparation
3.1.1 Battery Installation