Operating Precautions
This section presents important information intended to ensure safe and
effective use of the printer. Please read the following carefully.
Notes on Safety
Be sure to use the specified battery and power source provided by our
company. Connection to an improper power source may cause fire,
explosion or damage to the printer.
Don’t put the battery into the fire or water, don’t disassemble or modify the
battery, don’t be short circuit, otherwise may result in injury or fire even
explosion.
If the printer would not be used for a long time, be sure to take off the
battery, otherwise the battery may leak liquid which is corrosive, if
improper operation causes battery leak, and the liquid is spattered on the
skin or clothes, please wash it with water, if spattered in the eyes, please
rinse them with water thoroughly and see a doctor.
Please do not open the paper case cover when it is printing or just when
printing is over, do not touch the print head with hand or body, overheat
may cause scald.
Notes on Using
Be sure not to print continuously over 1 meter, otherwise may cause
damage to the print head.
Water or other liquid should not spill into the printer, also the printer
should not be appeared in the rain, or else may cause printer damage.
Please do not open the paper case cover when it is printing, otherwise the
printer may work improperly.
If print with serial interface, should not unplug the interface cable in the
course of printing, or else some printing data may be lost.
When print in Ir or IrDA mode, be sure the Ir window of the host
equipment face rightly the Ir window of the printer, the distance should be
within the range of 50mm, and the angle should be within the range of 30
o
.
When print with Bluetooth interface, the communication distance should
be within 10 meters, otherwise the printer doesn’t print or prints rubbish
codes.
To Next Page
Loading...