Mobius M210 - Cleaning; Maintenance; Lifting & Moving

19
MOBIUSTRIMMER.COM
CLEANING
MAINTENANCE
LIFTING & MOVING
With the exception of the motor, gearbox, and electrical enclosure, the MOBIUS M210 MILL can be
washed, cleaned, and wiped down with normal detergents, degreasers, and disinfectants.
The access door, rotor, and screen can be removed to facilitate cleaning. The inside of the MOBIUS
M210 MILL can be washed and wiped as needed.
The door gasket can also be removed easily for cleaning. This gasket is pressed by hand into the
groove around the circumference of the door.
The exterior of the MOBIUS M210 MILL should never be hosed or sprayed. Evidence of water near the
motor, conduit, electrical panel, or gearbox could void the machine warranty.
The MOBIUS M210 MILL is largely maintenance-free.
The door gasket is the only wear component within the Mobius Mill. The condition of the door gasket
should be inspected prior to each use. A faulty or worn door gasket will not affect the operation of the
machine, however it is necessary for dust mitigation.
The M210 gearbox is a fully sealed unit and is 100% Maintenance free for life.
This User Guide does not include instructions for machine repair. For your safety, repairs must be
completed by ETEROS TECHNOLOGIES or an authorized agent (service technician).
Should repairs be required, please contact:
ETEROS TECHNOLOGIES
502-130 INDUSTRIAL AVE.
CARLETON PLACE, ONTARIO, CANADA
K7C 3T2
www.eteros.com
Improper interfacing, improper repair, or unauthorized modication could result in void warranty claims.
The machine is easily moved and rolled on level surfaces. The machine includes four locking swivel
casters that are installed at the factory. The machine is designed to be operated on smooth and level
oors.
If lifting is required, the M210 must be lifted using a forklift on the lower structural frame between the
casters. Ensure that the forks are fully spread to avoid overturning or ipping off the forks.