User Manual Mobius Maxi 4K Camera Version: V2.0
16
-Video AE Mode
To set video image exposure value. Minus side, darker; Plus side: brighter.
-Video EIS (Image Stabilizer)
To turn on / off video Image Stabilizer
Note: EIS is only supported for 4K 30fps, 2.7K 30fps, 1440p 30fps, 1080p 30fps and 1080p 60fps.
Note: Turn off Video Time Stamp when EIS is on.
-Video File Length (Video Clip Length)
Camera will record videos clips in the set length. When the clip length is reached the camera will stop / save the
current video clip and continue recording the next clip, until card is full or battery is running out.
Consecutive clips of 1 Minute, 3 Minutes, and 5 minutes are seamless (no loss of video frames or audio)
Clip length set for Max length will stop / save / continue a new clip when the 4GB (for FAT32) and 60GB (for exFAT)
file size limit is reached.
Clip length set to 10 Minutes may not have 10 minutes if the video data rate is very high and the 4GB (for FAT32)
file size limit is reached before 10 minutes. 10 Minutes and Max clips may not be seamless.
-Video Loop Record (Loop Recording)
To continue recording when memory card is full. Default is off.
When set to On, the camera will continuously record, overwriting the oldest files when the card is full.
Warning! Make sure to back up important files.
Note: Loop Record is only supported for video clip length 1 minute, 3 minutes and 5 minutes. Shorter video clip
length can also minimize the risk of data lost in case of card issues.
This setting must be On, in order to use Gravity sensor to flag and lock Event video file while detecting an impact.
-Video Time-lapse Interval (Time-lapse Video)
To record video images at a specific slow interval such as one frame every second.
When the video is played back at average speed (e.g. 30fps), the scenes appears to move much faster.
It’s the opposite of slow motion video.
Note: no audio for time-lapse video.
-Video Slow Motion (Slow Motion Video)
Slow motion video only supports 1080p 120fps and 720P 120fps / 240fps, videos playback in 30fps
-Video FOV (Field of View)
To change the viewing angle, the area that the camera can see.
Default is Wide, full FOV of camera. You may want a narrower image with less distortion than a wide angle image.
Medium or Narrow FOV is only supported for 2.7K 30fps / 60fps; 1440P 30fps / 60fps; 1080P 30fps / 60fps
-Video WDR (Wide Dynamic Range)
You could enable Wide Dynamic Range in bad lighting conditions.
It’s recommended to use with Video Auto Low Light.
-Video Auto Low Light
To get best low light performance, for indoor lights and night lights, etc.
-Video Stamp Mode (Image Time Stamp)
Date /Time stamp is on by default. You can turn it off or set it to show Date only.
-Motion Detect
When it’s set On, it will start video recording when sensor detects motion.
It's Off by default.
-Motion Detect Timeout
If no motion is detected within a specific time frame, camera will stop video recording and return to standby mode
and wait for new motion detection. Only valid when Motion Detection is On.
-Motion Detect Sensitivity
To set the motion sensitivity. Only valid when Motion Detection is On.
(Back to Table of Contents)
To Next Page
Loading...