It is designed so that the USB stick always remains plugged into the MC device. This ensures that a change
of the configuration takes place in the Config-Stick as well as a change of the MC-firmware is also stored in
the USB stick. Thus, another MC device that is started with this Config-Stick will have the same function as
the MC device from which the Config-Stick was removed.
If the USB stick is removed, the MC makes a reset very soon. The following boot process is stopped until a
Config USB memory stick is detected. Until then the MC remains blocked. This state is signaled with a blue
flicker of the power LED. If you want to run the MC again without Config-USB memory stick, you have to set
the MC via the Resettaster to "Factory Default"
MC Manual Version 2.10c
To Previous Page
Loading...
