www.modecom.eu
6
MODECOM GPS NAVIGATOR
PART I.
BASIC OPERATION
Part I guides you through the process of getting your device running,
familiarizes you with the external components, and tells you how to
customize system settings.
1. Getting Started
This chapter gives you step by step instruction for the initial startup
and introduces you to the external components of your device.
1.1 Setting the ON/OFF Switch
The ON/OFF switch should be set to the ON position for normal ope-
ration. Pull out the stylus pen and use it to slide the ON/OFF switch
to the ON (left) position.
CAUTION: Always leave the ON/OFF switch in the ON position for nor-
mal operation.
1.2 Connecting to AC Power and
Charging the Battery
Fully charge the battery before using your device for the rst time.
1. Connect the adapter cable to the connector on the left side of your
device.
2. Plug the AC adapter into a wall outlet.
• The charge indicator is blinking orange when charging is in pro-
gress. Do not disconnect your device from AC power until the batte-
ry is fully charged. This will take a couple of hours.
On / O Switch Reset
To Next Page
Loading...
Need help?
General
