Modena Piazza Series - PART 6: TROUBLESHOOTING; Exhaust Hood Not Working

27
Changing the Light Bulb
1. Turn off the Hood and unplug the power cord.
2. Disconnect the wire and remove the lamp from
exhaust hood body.
3. Change the bulb with the same size and power
type.
4. Install the new lamp on the exhaust hood body
and reconnect the wire
Do check the things below before contacting our Service Center, if there is any
interference with your exhaust hood :
Problem
Possible Cause
Recommended Action
Exhaust hood is not
working
• Power cord is not yet
connected to the
electrical socket.
• Electrical socket does not
have any electricity
• Connect the power cord to the
electrical socket.
• Connect the power cord to a
properly functioning electrical
socket
Deteriorating of
Suction Power
• Dirty aluminum filter
• Dirty carbon filter
• Clean the aluminum filter, dry it
and place it back on the exhaust
hood.
• Replace the carbon filter with a
new one.
Motor fan is not
functioning
• Motor coil is broken
• Contact MODENA Call Center
Motor stops
working after a
while
• Safety thermal regulator
is active
• The vent hood is installed too
close to the stove.
• Air circulation is not optimal.
• Contact MODENA Service Center.
PART 6: TROUBLESHOOTING
PART 7: PRECAUTION