15
Chimney installation
For Glass model and T shape model
• By put the upper chimney into lower chimney. Then pulling out the upper
chimney upwards. Adjust to reach the height required.
• Sliding the chimney to adjust the chimney height. When the height you
required is reached, then hang the fixing hole to the fixing screws as showed
in below pictures
NOTE
• Make sure the filter is securely locked.
Otherwise, it would loosen and cause
dangerous.
• When activated carbon filter attached,
the suction power will be lower.
• Carbon filters are installed at the rear of
the grill and had to be replaced after
three months.
To Next Page
Loading...
