Moeller DF6-340 Series - Keypad

02/02 AWB8230-1449GB
1
Quick Reference Guide DF6 Frequency Inverter
Keypad
The following illustration shows the LCD keypad of the DF6.
Table 1: Explanation of the operating and indication elements
Figure 1: Keypad view
For an explanation of each of the elements, a table 1.
a b c
d
e
f
g
h
i
jkl
m
n
o
RUN
PRG
ALARM
POWER
Hz
V
A
%
kW
MIN
MAX
PRG
ENTER
Number Name Explanation
a RUN LED LED lights up in RUN mode if the
frequency inverter is ready for operation
or operational.
b
7 segment
display
Display for frequency, motor current,
fault messages, etc.
c
POWER LED LED is lit when the frequency inverter
has power.
d
Alarm LED LED is lit when a fault has occurred
e
Hz LED Indication in b: Output frequency (Hz)
f, g
V, A, kW LED Indication in b: Either output voltage
(V) or output current (A) or a combined
current and voltage factor (kW)
h
LED % Indication in b: Torque in %
i
Potentiometer
and LED
Frequency setpoint setting
LED is lit when the potentiometer is
activated.
j
ENTER key This key is used for saving entered or
changed parameters.
k
Arrow keys Selecting functions, changing numeric
values
Increase
Reduce
l
PRG key For selecting and exiting the
programming mode.
m
OFF key Stops the running motor and
acknowledges a fault message. Active
by default, also when actuation is
through terminals.
n
On key and
LED
Starts the motor in the specified
direction (not active by default).
o
PRG LED LED is lit during parameterization.
ENTER
PRG