Glove80 Layout Editor 26
Loading new ZMK firmware onto your Glove80 27
Putting Glove80 into Bootloader for firmware loading 29
Entering bootloader mass storage device mode from ZMK 30
Entering bootloader mass storage device mode on power-up 30
Replacing keycaps to match key layout 31
Customizing the tenting angle 33
Benefits of tenting 33
How to adjust the tenting angle 33
For lower angle tenting adjustments 34
For higher angle adjustments (up to roughly 25/30 degrees) 34
Appendix: Specification 36
Appendix: ZMK 37
Creating a ZMK config repo and building ZMK firmware the “traditional way” 37
Appendix: Custom mounting 38
How to custom mount 39
Leg stud positions 39
Installing tripod mounting plates 40
Preparing the non-quick-release tripod mounting plate 41
Preparing the quick release mounting plate 41
Appendix: More Customizations 42
Extending the Glove80 electronics 42
Sidecar Module 44
Appendix: Glove80 with switches-not-soldered option 45
Replacing and soldering key switches 45
Appendix: Compliance and Certifications 47
USA 47
Canada 47
Page 3 Glove80 User Guide
To Next Page
Loading...