A quick test drive of Glove80
Procedure:
1. Plug in the USB cable to the left half of your Glove80
2. Plug in the other side of the USB cable to a host, such as a PC
3. Switch on both the left and right halves by pushing in the power button on each half
4. Start typing
If all goes well you should see the keystrokes showing on the host.
Your Glove80 is shipped with its battery partially charged. We recommend fully charging both
halves before using Glove80. Sometimes the battery may have depleted during storage and
shipping, in which case please charge batteries on both hands before the test drive.
Page 9 Glove80 User Guide
To Next Page
Loading...