Preparing the non-quick-release tripod mounting plate
1. Peel off the protection sheets from the 2 tripod plates. The protection sheets are the
brown layer on both sides of the acrylic plates for protecting against scratches during
transport.
2. Attach your tripod gear through the hole in the middle of the tripod mounting plate.
3. Secure your tripod gear to the tripod mounting plate by installing and securing the tripod
nut in the Tripod Mounting Plate Accessories Bag.
Preparing the quick release mounting plate
1. Peel off the protection sheets from the 2 tripod plates. The protection sheets are the
brown layer on both sides of the acrylic plates for protecting against scratches during
transport.
2. Take out the two quick release ball joints from the cardboard boxes
3. Peel off the double-sided tape on each of the two quick release ball joints
4. Attach a quick release ball joint to the rectangular trough in the middle of a mounting
plate, lining up the rim of the quick release ball joint with the trough.
5. Screw tight the tripod nut in the Tripod Mounting Plate Accessories Bag to secure the
quick release ball joint.
Page 41 Glove80 User Guide
To Next Page
Loading...