Moffat turbofan E25 - Bake Timer; Thermostat; Relay; Element

Revision 6/F3501
© Moffat Ltd, August 2006 E25 Convection Oven
-24-
Two
Screws
Two
Screws
Two Screws
6.3.6 BAKE TIMER
1) Remove bake timer knob by pulling it
firmly away from control panel.
2) Open control panel (refer 6.2.1) and undo
two screws securing timer.
Top Element
Two Screws
6.3.9 ELEMENT
6.3.7 THERMOSTAT
1) Pull knob off front of thermostat
2) Open control panel (refer 6.2.1) and undo
two screws securing thermostat.
3) Transfer wires to new timer.
4) Withdraw old timer and insert new timer,
securing with screws.
5) Replace knob.
Two Screws
Figure 6.3.6
5) Withdraw old thermostat phial through
rear of oven.
6) Insert new thermostat.
7) Re-assemble in reverse order.
3) Transfer wires to new thermostat.
4) Remove service panel (refer 6.2.2) and
from inside of oven loosen two screws
holding thermostat phial bracket.
Figure 6.3.7
Figure 6.3.8
1) With service panel and baffle removed
(refer 6.2.2 and 6.2.3) remove the wires
from the element(s).
2) Unscrew the element from inside the
oven.
3) Pull element carefully to remove.
4) Replace and re-assemble in reverse
order.
Figure 6.3.10
Element Ratings
100-120V Top Element 7.2 ohms
Fan Element (E25) 9.3 ohms
220-240V Fan Element 28.8 ohms
Fan Element (E25B) 7.2 ohms
6.3.8 RELAY
1) Remove service panel (refer 6.2.2).
2) Undo two screws securing relay to oven.
Figure 6.3.9
3) Transfer wires to new relay, and secure to
oven with screws.
Broil
Relay
Heating
Relay
Fan Element
Three Screws