What does 'safe temperature limit exceeded' mean on Molecular Devices SpectraMax M2e Laboratory Equipment?
If Molecular Devices Laboratory Equipment detects a temperature over 50°C on one or more of the thermistors, it will display a 'safe temperature limit exceeded' error. The temperature will shut off and remain off until a successful completion of power-up reset.
What does 'NVRAM CRC corrupt' mean on Molecular Devices Laboratory Equipment?
An 'NVRAM CRC corrupt' error in Molecular Devices Laboratory Equipment means that the CRC for the NVRAM data is corrupt.
What causes a 'thermistor faulty' error in Molecular Devices Laboratory Equipment?
A 'thermistor faulty' error in Molecular Devices Laboratory Equipment means the thermistor is either faulty or disconnected, there's a main board problem, or the ambient temperature is out of range. The equipment is unable to read a reasonable thermistor value.
Why am I getting a 'no data to transfer' error on my Molecular Devices SpectraMax M2e Laboratory Equipment?
A 'no data to transfer' error in Molecular Devices Laboratory Equipment means you are inputting transfer when there is no data in the buffer.
What does 'serial port parity error' mean on Molecular Devices Laboratory Equipment?
A 'serial port parity error' in Molecular Devices Laboratory Equipment means a parity bit error was detected with incoming serial data.
What does 'NVRAM Carriage offset error' mean on Molecular Devices SpectraMax M2e Laboratory Equipment?
An 'NVRAM Carriage offset error' in Molecular Devices Laboratory Equipment means the carriage offset data is unreasonable.
What to do if Molecular Devices SpectraMax M2e gain calibration failed?
If the gain calibration fails on your Molecular Devices Laboratory Equipment, check for a bad or disconnected pre-amp or excessive stray light.
How to fix Molecular Devices SpectraMax M2e drawer that does not open?
If the drawer on your Molecular Devices Laboratory Equipment is not opening, try the following: * Turn the instrument off and then on again. * Turn the power off, locate the groove in the upper left side wall of the door using your thumbnail, open the door, and pull the microplate drawer out of the instrument.
What to do if Molecular Devices SpectraMax M2e detects low light?
If your Molecular Devices Laboratory Equipment is showing a low light detection, you can check if the cuvette door is open.
What to do if Molecular Devices SpectraMax M2e shows reference level saturation?
If you are getting reference level saturation on your Molecular Devices Laboratory Equipment, a possible solution is to check if the cuvette door is open.
General| Brand | Molecular Devices |
|---|---|
| Model | SpectraMax M2e |
| Category | Laboratory Equipment |
| Language | English |
Details on pathlength compensation technology and its correction methods.
Instructions for safely removing the instrument from its packaging.
Guidelines for placing, connecting, and initial setup of the instrument.
Steps for powering on, setting temperature, and loading samples.
Guidance on adjusting settings for optimal fluorescence detection.
Step-by-step instructions for replacing instrument fuses.
Procedure for manually opening the drawer in case of errors.
Lists error codes and their likely causes and remedies.
To Next Page
