What does 'NVRAM CRC corrupt' mean on Molecular Devices Laboratory Equipment?
An 'NVRAM CRC corrupt' error in Molecular Devices Laboratory Equipment means that the CRC for the NVRAM data is corrupt.
What to do if Molecular Devices SpectraMax M2e shows signal level saturation?
If the signal level is saturated on your Molecular Devices Laboratory Equipment, verify that the cuvette door is not open.
What to do if Molecular Devices SpectraMax M2e shows reference level saturation?
If you are getting reference level saturation on your Molecular Devices Laboratory Equipment, a possible solution is to check if the cuvette door is open.
What does 'assert failed' mean on Molecular Devices SpectraMax M2e?
Firmware error.
What does 'input line too long' mean for Molecular Devices SpectraMax M2e?
The 'input line too long' error in Molecular Devices Laboratory Equipment means there are too many characters in the input line.
What does 'NVRAM Carriage offset error' mean on Molecular Devices SpectraMax M2e Laboratory Equipment?
An 'NVRAM Carriage offset error' in Molecular Devices Laboratory Equipment means the carriage offset data is unreasonable.
What is a carriage motion error in Molecular Devices SpectraMax M2e Laboratory Equipment?
A 'carriage motion error' in Molecular Devices Laboratory Equipment means the carriage did not move to either of its photo interrupts in a reasonable time, or cannot find its photo interrupt.
What does 'plate air cal fail, low light' mean on Molecular Devices SpectraMax M2e?
A 'plate air cal fail, low light' error in Molecular Devices Laboratory Equipment means the minimum signal/reference ratio was not met during air calibration.
What does 'unknown interrupt' mean on Molecular Devices Laboratory Equipment?
Firmware error.
What causes a 'thermistor faulty' error in Molecular Devices Laboratory Equipment?
A 'thermistor faulty' error in Molecular Devices Laboratory Equipment means the thermistor is either faulty or disconnected, there's a main board problem, or the ambient temperature is out of range. The equipment is unable to read a reasonable thermistor value.
Details on pathlength compensation technology and its correction methods.
Instructions for safely removing the instrument from its packaging.
Guidelines for placing, connecting, and initial setup of the instrument.
Steps for powering on, setting temperature, and loading samples.
Guidance on adjusting settings for optimal fluorescence detection.
Step-by-step instructions for replacing instrument fuses.
Procedure for manually opening the drawer in case of errors.
Lists error codes and their likely causes and remedies.
General| Brand | Molecular Devices |
|---|---|
| Model | SpectraMax M2e |
| Category | Laboratory Equipment |
| Language | English |
To Next Page