What to do if Molecular Devices SpectraMax M2e shows reference level saturation?
If you are getting reference level saturation on your Molecular Devices Laboratory Equipment, a possible solution is to check if the cuvette door is open.
What to do if Molecular Devices SpectraMax M2e detects low light?
If your Molecular Devices Laboratory Equipment is showing a low light detection, you can check if the cuvette door is open.
How to fix Molecular Devices SpectraMax M2e drawer that does not open?
If the drawer on your Molecular Devices Laboratory Equipment is not opening, try the following: * Turn the instrument off and then on again. * Turn the power off, locate the groove in the upper left side wall of the door using your thumbnail, open the door, and pull the microplate drawer out of the instrument.
What to do if Molecular Devices SpectraMax M2e gain calibration failed?
If the gain calibration fails on your Molecular Devices Laboratory Equipment, check for a bad or disconnected pre-amp or excessive stray light.
What to do if Molecular Devices SpectraMax M2e shows reference gain check fail?
If the reference gain check fails on your Molecular Devices Laboratory Equipment, check for a bad or disconnected pre-amp board or excessive stray light.
What to do if Molecular Devices Laboratory Equipment has a fatal error on power up?
If your Molecular Devices Laboratory Equipment displays a fatal error upon powering up, record the error message number and contact Molecular Devices Technical Support or your local representative for assistance.
Why am I getting stray light errors with my Molecular Devices SpectraMax M2e?
Stray light in Molecular Devices Laboratory Equipment could be due to a light leak in the read chamber or the cuvette door being open. It could also indicate a faulty pre-amp board.
What to do if Molecular Devices SpectraMax M2e detects stray light?
If your Molecular Devices Laboratory Equipment detects stray light, you should check for a light leak in the reading chamber or see if the cuvette door is open.
What causes a 'low light' error on Molecular Devices SpectraMax M2e?
A 'low light' error with Molecular Devices Laboratory Equipment means that not enough light is detected to make an accurate measurement. If you're doing a cuvette read, the cuvette door might be open.
What does 'safe temperature limit exceeded' mean on Molecular Devices SpectraMax M2e Laboratory Equipment?
If Molecular Devices Laboratory Equipment detects a temperature over 50°C on one or more of the thermistors, it will display a 'safe temperature limit exceeded' error. The temperature will shut off and remain off until a successful completion of power-up reset.
General| Brand | Molecular Devices |
|---|---|
| Model | SpectraMax M2e |
| Category | Laboratory Equipment |
| Language | English |
Details on pathlength compensation technology and its correction methods.
Instructions for safely removing the instrument from its packaging.
Guidelines for placing, connecting, and initial setup of the instrument.
Steps for powering on, setting temperature, and loading samples.
Guidance on adjusting settings for optimal fluorescence detection.
Step-by-step instructions for replacing instrument fuses.
Procedure for manually opening the drawer in case of errors.
Lists error codes and their likely causes and remedies.
To Next Page
