25
Conductor Height Adjustment
Note
It is desirable to adjust the conductor adjustment wheel all the way to (1) on the conductor adjustment indicator, to
avoid punch crash prior to beginning this process.
Steps
(Ref. Fig. 7)
1. Replace the press guard.
2. Prepare wire for crimping. The selected wire should meet the parameters on the specification sheet.
3. Make sure that the 10 mm hex head Allen wrench is removed from the back of the press.
4. Turn the power on.
5. Place the wire through the slot in the press guard and all the way to the Terminator wire stop.
6. Activate the foot pedal, sweeping the crimped wire to the right.
7. Measure the crimped wire and verify desired crimp height on the specification sheet.
8. If crimp height adjustments are required, power down the press and remove the press guard.
9. Loosen the 6 mm crimp height locking screw and rotate conductor adjusting screw. Rotating the conductor
adjusting screw clockwise one full turn will tighten the crimp height approximately 0.03mm (.001”).
10. Repeat steps 1 thru 9 until the correct crimp height is achieved.
11. When correct crimp height is achieved tighten 6 mm lock screw.
12. Replace the press guard.
To Next Page
Loading...