23
Forward and Back Feed Adjustment
Note
Because of different terminal progressions, feed adjustment may be necessary.
Steps
(Ref. Fig. 6)
1. Make sure the press ram is in the fully up position and the clutch collar is engaged by the actuator.
2. Slide the terminal carrier strip all the way forward until it is centered over the anvils.
3. See the feed finger location (Fig. 5) for feed finger position.
4. Rotate the feed finger shaft with small screwdriver or 6” scale to get desired feed finger spring pressure
and tighten shaft locking screw.
5. Loosen 6 mm feed adjustment wheel locking screw.
6. Turn the feed adjustment wheel if necessary to position the terminal over the anvils.
7. Place the 10 mm hex head Allen wrench in the 12 mm S.H.C.S. located in the back of the press and slowly
hand cycle the press to the fully down position.
8. The feed finger should start to move backward one progression, if not loosen the 6 mm jam nut and back
the set screw out enabling the feed finger to move to the next pick up point.
9. If the feed finger is moving back more than one progression rotate the 6 mm set screw clockwise until the
feed finger is in the correct pickup point.
10. Hand cycle the press ram a few times and if necessary make the appropriate adjustments.
11. Tighten M6 lock nut and 6 mm feed adjustment locking screw.
To Next Page
Loading...