13
Terminator Die Installation & Removal
CAUTION
Always power down the press when installing or removing Molex tooling by pressing the emergency stop button located on
the front panel.
STEPS
(Ref. Fig. 1)
1. Remove Press guard. (Ref. Press or Base Unit manual.)
2. Confirm that the Terminator is correct for the specified product. (Ref. Specification sheets supplied with the
Terminator.)
3. Make sure all the tooling from a previous setup is removed. (See Step 11.)
4. Load all top tooling first, starting with the rear striker. (See Fig. 16.)
5. Pull on punch release pin to install punches into the punch cavity.
6. Finish with front striker (if specified). Confirm that all components follow assembly drawing sequence.
7. Clean bolster plate of scrap or chips that may interfere with the Terminator base installation.
8. Remove 6 mm S.H.C.S (TM42) and lift the right locating plate from the bolster.
9. Place the Terminator base on the bolster plate and slide to the left. The slot in the base will locate on the
left guide block
10. Replace the right locating plate and tighten 6 mm screw.
11. To remove the Terminator reverse the above steps.
To Next Page
Loading...