19
Punch and Anvil Alignment
Note
Correct punch and anvil alignment will insure quality crimps and excellent tool life.
Steps
(Ref. Fig. 4)
1. Slightly loosen the anvil mounting screws.
2. Place the hand cycling wrench through the hole in the center of the rear cover.
3. Gently lower the press ram until it is in the fully down position, with a terminal sitting on the the anvils the
punch will align the bottom tooling.
4. With the ram in the fully down position tighten the anvil mounting screws.
5. Bring the ram back to top dead center insuring that the clutch collar is engaged by the actuator.
6. Repeat the hand cycling operation to confirm alignment.
To Next Page
Loading...