15
Loading The Terminal Strip
Note
Terminator Drag mechanism may vary on product selection or Terminator type.
Steps
(Ref. Fig. 2)
1. Confirm terminal part number matches the terminator specification sheet.
2. Install the terminal reel on the press reel holder.
3. Raise the drag plate (T2) and slide the terminal strip under both the cover plate and the drag plate.
4. For other “T” style Terminators, raise the drag finger and anti backup finger.
5. Ease the terminal strip forward until the first terminal on the strip is sitting on the anvils.
6. If severe resistance is encountered or the terminal strip does not fit, you may need to make a cover plate
adjustment.
Removing The Terminal Strip
Steps
1. Raise Terminal Drag plate or “T” style drag finger and anti backup finger.
2. Lift the Feed Finger from the carrier strip
3. Gently pull on the terminal strip until it has exited the track.
To Next Page
Loading...