29
Operation
Note
Check that all setup procedures were followed and all locking screws have been tightened. Follow the safety and
work area instructions.
Steps
(Ref. Fig. 9)
1. Press guard should be in position.
2. Wire should be pre stripped and prepared for crimping.
3. Place pre stripped wire through the slot in the press guard.
4. Touch pre-stripped wire against the wire stop.
5. Press foot pedal down once.
6. Use sweeping motion to the right with the crimped wire.
7. Check the crimped wire and confirm that it meets the Terminator specifications and visual inspection.
To Next Page
Loading...