C. Live Circuits
Component replacement and internal adjustments must be made only by
qualified Maintenance Personnel. Do not replace components with power
connected. Under certain conditions, dangerous voltages may exist even
with the power removed. To avoid injuries, always disconnect power and
discharge circuits before touching them.
D.
Two Service Persons Required
It is recommended that another person be present when internal service or
adjustments are attempted in order to render assistance if necessary.
E.
Substitutions or Modifications
Do not install substitute parts or perform any unauthorized modifications
to the equipment before consulting with Monaco to ensure that safety
features are maintained.
2.2.2
Equipment Protection
The following general requirements must be observed during all phases of
operation, service, and repair of this equipment. Failure to comply with
these precautions or with specific warnings elsewhere in this manual may
cause considerable damage to the equipment. Monaco assumes no liability
for the Customers' failure to comply with these requirements.
A.
Power Removal
Removal of individual assemblies or their subcomponents must be done only
after power is removed from the particular equipment. This includes both
line power and battery power.
555
N
DOCUMENT
NO.
001-097-00
PAGE
2-2
Monaco Ente~p~ises
INC.
SPOKANE WASHINGTON
99214
To Next Page
Loading...