Turn Signal and Lane Change Indicator
The turn signal has two upward (for right) and two downward (for left) positions.
These positions allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down. When the turn is finished,
the lever will return automatically.
To signal a lane change, raise or lower the lever until the arrow starts to flash.
Hold it there until you complete your lane change. The lever will return by itself when
you release it.
If the arrows do not flash but just stay on when you signal a turn or a lane change,
a signal bulb may be burned out and other drivers will not see your turn signal.
If a bulb is burned out, replace it to help avoid an accident. If the arrows do not
go on at all when you signal a turn, check the fuse and for burned out bulbs.
Headlamp High/Low Beam Changer
To change the headlamps from low beam to high beam, or high to low, pull the turn
signal lever all the way toward you, then release it.
W
iper/Washer Operation
Push button to wash position and release. Wash solution is delivered within
approximately 5 seconds and wipers will turn on and off automatically. A continuous
wash and wipe is performed as long as wash button is activated.
When rotating smart stick section from OFF to delay, you will turn wipers on and
a delay between wipes (ranging from 45 seconds to 2 seconds) will occur. Delay time
changes as stick is turned forward. A continuous low or high speed can be obtained by
rotating section to appropriate position. To turn wipers off rotate stick to OFF position.
Cruise Control
With cruise control, you can maintain a speed of about 25 mph (40 km/h) or more
without keeping your foot on the accelerator. Cruise control does not work at speeds
below about 25 mph (40 km/h).
When you apply your brakes, the cruise control shuts off.
Monarch 9-9
MONACO
2000
Chassis Information
Chassis Information
To Next Page
Loading...
