EasyManua.ls Logo

Monaco Monarch 2000 - To Convert Dinette into a Bed

Default Icon
123 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If step switch is turned off after step has been fully extended for approximately
5-10 seconds, step will not retract when closing door.
When motorhome ignition key is in RUN position, step will always extend and
retract with door regardless of step switch position.
Any time step switch is on and door is open, an amber light under the step will
be illuminated placing a drain of approximately 1/2 amp on chassis battery.
Operation (Last Out)
If step is in extended position with step switch off and door closed, starting
engine or placing ignition key in RUN position will cause step to automatically
retract.
When engine is stopped and ignition key is returned to OFF position, open-
ing door will cause step to extend.
Allow step to fully extend and wait approximately 5-10 seconds before closing
door.
Step will remain extended until step switch is returned to ON position or igni-
tion key is rotated to RUN position.
NOTE: Not allowing step to fully extend and remain extended for 5-10 seconds before
closing door may cause step to retract. Opening door after this will cause no step exten-
sion until step switch is returned to ON position.
To Convert Dinette Into a Bed
Remove dinette seat cushions from seats.
Lift up on end of table and release lock on leg.
Swing table leg back until it locks.
Pull table away from ledge and lower it down until table lays on ledge of dinette
seat.
Table is hinged for easy movement. Lay table on dinette seat ledges and spread
cushions out to form a mattress.
To return dinette to its original position, lift table back on to ledge on wall.
Release lock on leg and allow it to lock in outstretched position.
Lower table until leg rests on floor.
Monarch 3-21
Appliances & Equipment
Appliances & Equipment
MONACO
2000

Related product manuals