Attic Air Vent
The attic air vent will only draw air out of the motorhome. To operate fan, turn
switch to the high position. This will provide enough force to open the door of the fan
shroud. Once the fan has been turned on high to open the door of the shroud, choose
either the Low, Medium, or High settings for whatever your conditions dictate.
Periodically check all fasteners to make sure they remain tight. If fasteners become
loose, see that they are adequately retightened right away. Periodically check to make
sure the seal is still adequate where the fan is attached to the roof.
Furnace
Operating Instructions
• Set thermostat FAN control
to AUTO and either HI or
LOW settings.
• Set thermostat control 10
o
higher than motorhome air
temperature, control is locat-
ed at right side of thermostat.
• Set SYSTEM control to
HEAT.
• Allow 40 to 60 seconds for
furnace to begin operating.
• Set temperature to desired
setting.
• If furnace does not light, and you do not smell gas, repeat the above procedure.
• If furnace does not ignite after three attempts, slide thermostat control to OFF
and call a qualified service technician or your gas supplier.
• To shut down furnace, slide thermostat control to OFF. After you have turned
the furnace off, or burner has shut down, the fan will run for approximately 30
to 60 seconds to cool down the furnace.
Cleaning Furnace
Clean entire furnace and air tube passageways periodically to remove dust, lint,
etc. Check gas systems for leaks at least once a year. Check and clean blower wheel
annually. Control compartment of furnace must be kept clean; failure to do so could
result in operational or fire hazards.
Monarch 3-15
Appliances & Equipment
Appliances & Equipment
MONACO
2000
To Next Page
Loading...
