tor AC power cord must be plugged in and LP gas valve must be open for operation (refrig-
erator AC power cord is located in refrigerator outside compartment). Refer to Chapter 8
“Diagrams” for compartment locations. The refrigerator operates on AC current or LP
Gas.
Control Panel - 1200 Series
LED Display - Flashes a
LED fault code to diagnose an
abnormal operating condition.
ON/OFF Button - Press
button to turn refrigerator ON.
Press button and hold until no
lights are lit to turn refrigerator
OFF.
MODE Button - Pressing and holding button allows the user to cycle through three
choices; AUTO, AC and LP modes. The refrigerator will not switch to new operating mode
until the button is released.
TEMP SET Button - Press and hold button to select desired temperature setting.
Temperature settings appear in display between COLD and COLDEST range.
Manual Mode - 1200 Series
To operate in “MANUAL” mode, press and hold “MODE” button until desired oper-
ating mode (AC or LP) light is lit. If energy source is interrupted, a diagnostic code will
flash in LED display and an alarm will sound. Turn refrigerator OFF to silence alarm and
refer to refrigerator Operator’s manual for diagnostic meaning.
AUTO Mode - 1200 Series
• Press main power ON/OFF button so that any light is lit.
• Press TEMP SET button and hold until COLDEST reading is indicated.
• Press and hold MODE button to select AUTO setting then release button.
Operating control automatically selects one of the following:
1. When 120 volt AC is available, AUTO and AC lights will be lit indicating
refrigerator is operating on AC current. After 10 seconds AC light will go off
and AUTO light will stay lit. Press and quickly release MODE button to dis-
play operating mode.
Monarch
3-4
Appliances & Equipment
Appliances & Equipment
MONACO
2000
To Next Page
Loading...
