What causes the drain flow restrictor jammed sideways in the valve of Monarch Water Dispenser?
If the drain flow restrictor is jammed sideways in the valve of your Monarch Water Dispenser, it is caused by: * Wrong assembly direction. Change the direction of DLFC.
What causes corroded PCB and ribbon cable in Monarch Water Dispenser?
Corrosion on the PCB and ribbon cable in your Monarch Water Dispenser can be caused by: * Too long refill duration, leading to salt water entering the board of the PCB. Replace the PCB.
General| Type | Water Dispenser |
|---|---|
| Series | HE Series |
| Brand | Monarch Water |
| Heating Capacity | 5L/H |
| Material | Stainless Steel |
| Certification | CE |
Locating the softener, drain, and ensuring a level surface for installation.
Connecting the power supply and transformer to the softener unit.
Procedure for testing and determining the water hardness level.
Common causes and solutions for soft water issues.
Diagnosing why the softener is not regenerating.
Troubleshooting the brine draw process.
Steps for diagnosing a non-functional main PCB.
Interpretation and resolution of displayed error codes.
To Next Page
