What causes the drain flow restrictor jammed sideways in the valve of Monarch Water Dispenser?
If the drain flow restrictor is jammed sideways in the valve of your Monarch Water Dispenser, it is caused by: * Wrong assembly direction. Change the direction of DLFC.
What causes corroded PCB and ribbon cable in Monarch Water Dispenser?
Corrosion on the PCB and ribbon cable in your Monarch Water Dispenser can be caused by: * Too long refill duration, leading to salt water entering the board of the PCB. Replace the PCB.
General| Brand | Monarch Water |
|---|---|
| Model | Midi HE CS150 HE |
| Category | Water Dispenser |
| Language | English |
Guidelines for site selection, plumbing connections, and drain line setup.
Procedure for electrical hookup and method for testing water hardness.
Steps to configure the softener's time and water hardness settings.
Resolving problems where the water is not sufficiently softened.
Resolving excessive water or overflow conditions in the brine tank.
Steps to resolve when the softener does not perform its regeneration cycle.
Troubleshooting when the softener cannot draw brine from the salt tank.
Resolving issues related to the main PCB, corroded components, and power.
Understanding and resolving specific error codes displayed by the unit.
To Next Page
