Moneris Move 5000 - Using the direct-to-terminal charge cable

Moneris Core® Move/5000 Wireless Terminal: Setting up Your Hardware 5
Charging the battery
Charge the terminal’s internal battery for 4 hours using one of the following methods:
 Optional charge-only base (see below)
 Direct-to-terminal charge cable (see page 6).
Recommendations: Always plug the power cable into the power source last to avoid power surges. Use a power
bar equipped with surge protection where possible.
Important: You must use the exact power adaptor and cables provided by Moneris to work with the Moneris
Move/5000 terminal and base. Failure to do so may affect the operability of, or cause damage to, the
equipment.
Using the charge-only base
1. Locate the base’s power cable.
2. Turn the base over and open the panel cover on the underside of the
base.
Continued on the next page.