BATTERY BACK-UP SIREN (M80S/G/GNZ)
These models have a battery back-up siren. Vehicle battery disconnection will cause the battery
back-up siren to sound. The siren can be turned off with the special keys provided.
The siren is mounted under the bonnet and should be situated in a place to protect it from heat and
water damage. Driving through deep water or puddles may cause water splashes, so caution is
advised. Please check that the siren has been mounted in such a position so as to avoid damaging it.
If washing the engine bay, cover the siren with a plastic bag to prevent water damage. Heat or water
damage is not covered by the warranty.
AUTOMATIC RE-SET
Upon an intrusion (ie; door opened and closed), the siren will sound for 30 seconds, after which it
will stop and reset to the armed position. It will then re-trigger on the next intrusion.
If a door is left open, the siren will sound for 3 x 30 seconds and then that individual circuit will be
bypassed to avoid unnecessary noise.
(NSW, one sounding only - must be manually re-set after first trigger)
ARM CONDITION MEMORY
Should the vehicle battery be disconnected, the system memorises the last set position of the alarm.
If the alarm was disarmed prior to battery disconnection, reconnection does not cause the alarm to
sound. If the battery was disconnected whilst the system was armed, reconnection will return the
system to the armed state.
NOISE POLLUTION CONTROL
To reduce noise nuisance and possible false alarms, the system will isolate an individual circuit if it
is triggered more than three times in succession or is left open.
(Eg: 3 x bonnet, 3 x boot, 3 x doors, 3 x ignition, 3 x impact sensor, 3 x other sensor)
Reset by remote by disarming and then re-arming. Turn ignition ON/OFF to re-set LED intrusion
codes.
10
To Next Page
Loading...
