PANIC BY REMOTE (in either armed or disarmed state)
In the event of personal attack, or you suspect that your vehicle is being tampered with, the alarm
can be ‘panicked’ by pressing buttons one and two at the same time on the remote for more than 3
seconds. The siren will sound and the indicators will flash.
Cancel the panic, by pressing both buttons again.
Pressing button one whilst the siren is sounding will either arm or disarm the system depending on
the prior armed/disarmed state.
VEHICLE LIGHTS ON WARNING
If the lights are on when you arm the system, the siren will chirp once and then briefly produces a
different sound as a warning.
If you intended to leave the lights on, ignore this warning.
This helps to prevent your car battery going flat if you accidentally left the vehicle lights on when
exiting your vehicle.
AUXILIARY CHANNEL 2 OUTPUT (EG: BOOT RELEASE) – OPTIONAL CONNECTION
The system has an auxiliary pulse output which can be used, for example, to control a vehicle’s
electric boot release (f the vehicle is equipped). The output can be used for other purposes, please
discuss with your installer. This will usually incur additional charges.
Example of remote boot release;
Press button two on the remote for 3 seconds and the boot will unlock and open
The boot trigger circuit and interior sensors (if fitted) will be bypassed
Upon closing the boot the bypassed circuits will re-arm automatically
12
To Next Page
Loading...
