ROLLING CODE (RANDOM ENCRYPTION) REMOTE CONTROLS
Two remote controls are supplied with the system which enable you to arm and disarm your security
system.
The remote security code of your alarm system changes each time you press the remote button.
This coding system is referred to as Rolling Code and is completely random therefore eliminating
the possibility of anyone recording it (code grabbing).
The batteries in the remote controls should be changed when you notice any of the following;
System does not respond to the remote signal
Operation is intermittent
Reduced operating range
The remote LED fails to light
Replace batteries annually. Uses CR2032
If the remote gets wet due to submersion, immediately dismantle, remove the battery and dry as
soon as possible. If submersed in salt water, rinse in fresh water and dry.
Water ingress and any subsequent remote failure is not covered under the warranty terms.
CODE LEARNING NEW REMOTES TO YOUR ALARM
The main alarm module has a learning capacity to memorise up to four remote controls.
If you wish to add further remotes or a remote has to be replaced, the new remote needs to be code
learnt into the main module. If for instance you have lost a remote and are fearful that someone may
try to use it, the lost remote can be deleted from memory so it cannot be used.
An irregular or interruption to the vehicle’s power supply may cause loss of remote memory. If your
alarm fails to respond to the remote try re-learning them, or see your Mongoose dealer.
15
To Next Page
Loading...
