Mongoose M80i - Page 16

REMOTE CODE LEARNING cont’
 Disarm the system
 Open the drivers door and leave open
 Within 15 seconds, turn the ignition ON/OFF 3 times, 1~1.5 second apart
 The siren will chirp 3 times, the indicators will flash 3 times to confirm you have entered
remote code learning mode. (no chirps on M80i unless siren/horn connected)
 Press button one on the first remote – siren will chirp once as confirmation of reception
 Press button one on the second remote – siren will chirp twice as confirmation of reception
 Repeat for up to four remotes (siren will chirp 3 times for the third and 4 times for the
fourth).
 Leave the system for 10 seconds or turn the ignition on to end code learning mode. This is
confirmed by three fast chirps and light flashes.
NOTE: When learning a new replacement or additional remote, the original remote(s) must be
re-learnt or they will be erased from memory and will not operate this system.
To delete a remote from memory:
If you lose a remote, it is recommended that it is deleted from memory so someone else cannot use
it. Enter learning mode as detailed above and memorise the existing remote(s) once. The lost
remote is now deleted. When a replacement is obtained, learn both the existing and new remotes
into memory as detailed above.
16