BUILT-IN TURBO TIMER
The built-in turbo timer allows the engine to continue running (if installed for this feature) for a pre-
programmed time after the ignition has been turned off. This feature may be used to allow the
vehicles turbo/engine to cool down. In normal driving situations and to save fuel, the turbo timer
should not be necessary.
The timer is programmable for duration from 1 to 5 minutes - see ‘programming’.
To enable the turbo timer feature:- with the ignition on, press remote buttons 2 & 3 at the same time,
siren chirps once. The timer function will now always be ON each time the vehicle is used.
To disable the timer:- repeat the above procedure – siren chirps twice – timer is now off.
To stop the engine if already running:- press buttons 2 & 3 at the same time
NOTE: When the engine is running, arming the alarm does not immediately immobilise the engine
or turn on any sensors. An intrusion by opening any door, bonnet or boot will immediately stop and
immobilise the engine and trigger the alarm.
To arm with timer ON:-
Ensure the vehicle is in neutral gear or ‘park’ position and the handbrake is applied.
Turn the ignition off (engine remains running if timer is ON – engine stops if timer is OFF)
Exit the vehicle ensuring all doors, bonnet & boot are closed.
Arm the alarm by the remote – requires a longer press than normal (a couple of seconds).
After the programmed time, the engine stops, the immobilisers engage and sensors arm.
WHEN NOT TO USE THE TURBO TIMER
1. When this system has not been installed to allow for an engine turbo
2. When people or animals are still inside the vehicle
3. When doors or windows are to be left open
4. Is prohibited by country or state laws or by any other authority.
5. When doing so is likely to cause a risk or danger to others or property
6. When re-fuelling
7
To Next Page
Loading...
