OVERRIDE PIN CODE PROGRAMMING
Your security system is pre-programmed with a unique 4 digit PIN code as shown on the ‘PIN code
card’. You may wish to have your own code programmed to a number that is easier to remember.
Once changed, the factory setting is permanently erased.
1 Disarm the system using the remote control.
2 Disconnect all power feeds including the central locking connections to this system for
10 seconds (or disconnect the car battery – radio pre-sets/code will have to be re-set).
3 Reconnect the power and turn the ignition ON then OFF once.
4 Open & close the door (or press door switch) 5 times and leave closed.
The siren will give one long chirp and the lights will stay on to show learning mode.
If the code is, for example, 2-3-3-4
5 Turn ignition ON.
The LED lights for 3 seconds to show the start of the learning sequence. The LED will then
start to slow flash.
6 Allow the LED to flash twice for the first digit (2), then turn ignition OFF.
The LED will light for 2 seconds to confirm 1
st
digit input.
7 Turn the ignition ON and the LED starts to slow flash again.
8 Repeat steps 6 & 7 for the 2
nd
, 3
rd
& 4
th
digits.
9 After the 4
th
digit is accepted the PIN code learning programme will cease.
(Turning OFF the ignition & opening a door will also cancel this learning mode)
ARM THE SYSTEM AND TEST THE OVERRIDE PIN CODE FOR CORRECT OPERATION.
10 Amend the PIN code card with the new number, but do not leave in the vehicle !
18
To Next Page
Loading...
