9
Setting Up CP Loudspeakers
The following adjustments can be made to the tweeter on CP models except BR, RS & GS In-Wall, as follows:
1. Pivoting tweeters can be tilted up to 18 degrees in all directions to provide optimum coverage.
2. If the speakers are widely separated such that the music fails to blend into a central image when operated
in stereo mode then tilt the tweeter towards the listening area.
3. If the Soundstage seems too confined tilt the tweeter away from the listening area.
4. For further fine-tuning options of your CP In-Ceiling speakers please go to page 8.
Fine-tuning - In-Ceiling and In-wall speakers
The following adjustments can be made to your CP In-Ceiling and In-Wall loudspeakers as follows:
Adjusting H.F (High Frequency) control
(Silver RS CP and Gold CP models only)
The factory H.F setting provides a flat or 0dB level, which will suit the majority of typical installations. However, it is
possible to fine-tune the sound from the CP speakers to suit a room’s characteristics or preferred listening tastes by
using the following as a guide: -
a. Setting the switch in the +3dB position will add brightness and additional clarity to the system. This may be
effective in a room with a large amount of soft furnishings.
b. Setting the switch in the -3dB position will reduce the brightness on the system and provide a duller sound.
This may be effective in a room with a lack of soft furnishings, or in an installation with a wooden floor.
Adjusting M.F (Mid-range Frequency) control
(Gold CP models only)
The factory M.F setting provides a flat or 0dB level, which will suit the majority of typical installations. However, it is
possible to fine-tune the sound from the Gold CP In-Ceiling and In-Wall speakers to suit a room’s characteristics or
preferred listening tastes by using the following as a guide: -
a. Setting the switch in the +3dB position will add presence and additional clarity to the system, particularly in
the vocal region. This may be effective for better resolution of dialogue and speech, or in an installation where
the listening position is a large distance from the speaker.
b. Setting the switch in the -3dB position will reduce the presence and the system will sound more ‘laid back’.
This may be effective where the speaker will be played for background music, or where the listening position
is situated close to the speaker.
To Next Page
Loading...
Need help?
General
