To Next Page

To Previous Page

Bi-Wiring

Bi-wiring is accomplished by connecting separate pairs of speaker cables to the terminals on the loudspeaker

GSPNBTJOHMFQBJSPGDPOOFDUJPOTPOUIFBNQMJˌFS*OUIFDBTFPGUIF(PME4FSJFTUIFCPUUPNUFSNJOBMT

connect to the bass driver(s) and the top terminals connect to the tweeter in 2 way loudspeakers, or the mid

and tweeter in 2.5 and 3 way loudspeakers.

NOTE: When using this method the terminal links MUST be removed.

Bi-Amping

#J"NQJOHJTUIFTBNFBT#J8JSJOHFYDFQUZPVBSFJOUSPEVDJOHBTFDPOEBNQMJˌFSJOUPUIFFRVBUJPO

In order to Bi-Amp you must connect a set of speaker cables to the top terminals on the loudspeaker from

POFBNQMJˌFSBOEBOPUIFSTFUPGTQFBLFSDBCMFTUPUIFCPUUPNUFSNJOBMTGSPNUIFTFDPOEBNQMJˌFS

NOTE: When wiring this method the terminal links MUST be removed.

5IF&ˋFDUTPG#J8JSJOH#J"NQJOH

Fundamentally a loudspeaker crossover varies the impedance seen by the speaker and by the power

BNQMJˌFS5IFTJUVBUJPOJTTVDIUIBUXIFOUIFGVMMSBOHFNVTJDBMTJHOBMJTBQQMJFEUPUIFUFSNJOBMTPGBGVMM

range speaker system, the bass driver(s) only receives low frequency signals, the mid driver receives the mid

band frequency signals and the tweeter only gets sent high frequency signals. This means that if separate

speaker cables are connected to the low frequency terminals, and the high frequency terminals, not only

have the drive units and the frequency’s directed and divided for them, but the two separate speaker cables

XJMMOPXBMTPDBSSZEJˋFSFOUTJHOBMTUIFCBTTDBCMFNPTUMZUIFMPXTBOEUIFUXFFUFSDBCMFNPTUMZUIFIJHIT

Once the high and low frequencies have been separated in this fashion, the strong current pulses and surges

demanded by bass drivers when reproducing bass or drums, will not interact with the delicate sounds of a

ˍVUFPSDZNCBM

LEFT

RIGHT

AMP

LEFT

RIGHT

AMP

LEFT

RIGHT

AMP

Gold Series10

Monitor Audio GOLD SERIES User Manual

Questions and Answers: