Monster Power HTS2000 - STEP 2: Remote DC Control Hookup

STEP 2 Remote DC Control Hookup (HTS1000 CI and HTS2000 CI models only)
This feature allows you to turn your PowerCenter On via the remote control that operates
your A/V receiver or preamp.
A) Plug in the Remote DC control 1/8" minijack cable (not supplied) to the corresponding 12 volt remote trigger
input on the PowerCenter.
B) Plug in the other end of minijack cable to corresponding custom installation component is a 12 volt outlet.
7
PRESS
TO RESET
PROTECTION
ON
GROUND
OK
REMOTE DC
12V IN
IN
OUT
IN
OUT
IN
OUT
CATV
SAT
ANTENNA
PRE-AMP
TUNER
ACCESSORY
CD
TV/MONITOR
DVD/LD
VCR 2
VCR 1
CABLE/SAT
PHONE
IN OUT
CASSETTE AMP
RECEIVER
TV/MONITOR DVDCD CD RECEIVER/AMP
IN
OUT
IN
OUT
IN
OUT
CATV
SAT
ANTENNA
IN
OUT
PHONE
VCR CABLE/SAT ACCESSORY 1 ACCESSORY 2
Power Filters 10A Video Low Noise Filter
5A Audio Low Noise Filter
Filter Isolation 99% Above 100Khz Section to Section
Surge Supression 6000V/3000A 8/20µs Peak Transient Capacity
Coax Transient Suppression Less Than 1dB insertion loss to 1.5Ghz
3000V/150A 1/50µs Peak Transient Capacity
Phone Transient Suppression 3000V/400A 10/1000µs Peak Transient Capacity
SPECIFICATIONS
REMOTE DC
12V IN
HTS1000 CI (TOP VIEW)
HTS2000 CI (TOP VIEW)