8. PRIME/BOLUS: Used to prime uid through the tubing to clear it of air if your clinician has
instructed you to prime the tubing using the pump. If you have pain management therapy, this
key can also be used for your PCA doses instead of the bolus cord.
9. 2 & 4 NUMERIC KEYS: When your pump is running, you can press the #2 key to nd out
approximately how much battery life you have left. If you need to see the information on the
Infusion Running screen, you can press the #4 key to stop the screen and read the information. The
pump will return to the Running Screen after several seconds.
INSTALLING/CHANGING THE BATTERIES
1. If the pump is running, press the PAUSE key.
2. Turn the pump o by pressing the OFF key.
3. Turn the pump over.
4. Open the battery door by sliding the gray bar to the right to the “UNLOCK” position.
5. Remove the battery door by pulling the door downward.
6. Remove batteries by gently pulling outward on the plastic pull tab between the batteries if one is
present. If a pull tab is not present, remove the batteries from the top rst.
7. Insert the new batteries at bottom side rst (the at side is the negative pole). Insert them one at
a time.
8. Verify that the metal on the bottom of the batteries is in contact with the springs in the bottom of
the battery compartment.
9. If a plastic pull tab is present, ensure that the pull tab is between the batteries and not under the
batteries.
10. Push the top of the batteries into place.
Both batteries are placed in the same direction with the negative pole (at side) at the bottom
and positive poles at the top. Duracell ProCell “C” batteries are recommended. The “C” cell
batteries are NOT rechargeable.
11. Replace the battery compartment door by inserting the door in the notches at the bottom of the
pump and slide upward.
12. Lock the door by sliding the gray bar to the left to the “LOCK” position.
13. Turn the pump back over.
14. Turn the pump on by pressing the ON key. Wait for the pump to go through a self-test. This
should only take about 20 seconds.
15. Press YES to PROGRAM. PROGRAM should be highlighted on the screen (or press YES to LIBRARY
if instructed by your clinician).
16. Press YES to RESUME if you still have medication in the container. In this case RESUME should be
highlighted on the screen. If you are changing the medication container (bag) at the same time,
highlight REPEAT RX and press the YES key.
17. Press the RUN key when you are ready to start the infusion.
NOTE: If your pump is connected to AC power you can change the batteries without turning o the
pump.
3
To Next Page
Loading...
Need help?
General
