Moog Minimoog Tuning Procedure

OSC1
7) Turn on OSC1 in the mixer on the front panel. All other switches in the mixer should be
OFF.
8) Hold down the HIGH A key and adjust OSC1 RANGE trimpot for 3520hz.
9) Hold down the LOW A key and adjust OSC1 SCALE trimpot for 440hz.
10) Repeat steps 8 and 9 until no further adjustment is necessary.
The remaining adjustments can be done without the tuner or counter. You can monitor the
Minimoog with headphones or an amp.
OCTAVE
11) Hold down the LOW A key.
12) Turn on A440 on the front panel.
13) Adjust the front panel TUNE for unison.
14) Change the OSC1 RANGE switch on the front panel to 16.
15) Press the HIGH A key.
16) Adjust the OCTAVE trimpot for unison.
17) Set the OSC1 RANGE switch back to 2 and turn off A440.
OSC2
18) Turn on OSC1 and OSC2 in the mixer on the front panel. All other switches in the
mixer should be OFF.
19) Hold down the HIGH A key and adjust OSC2 RANGE trimpot for unison.
20) Hold down the LOW A key and adjust OSC2 SCALE trimpot for unison.
21) Repeat steps 19 and 20 until no further adjustment is necessary.
OSC3
22) Turn on OSC1 and OSC3 in the mixer on the front panel. All other switches in the
mixer should be OFF.
23) Hold down the HIGH A key and adjust OSC3 RANGE trimpot for unison.
24) Hold down the LOW A key and adjust OSC3 SCALE trimpot for unison.
25) Repeat steps 23 and 24 until no further adjustment is necessary.
You're done! Reinstall the rear cover and enjoy!

Moog Minimoog Specifications

General

Keyboard	44-note
Polyphony	Monophonic
Year Released	1970
Type	Analog
Oscillators	3
Filter	24 dB/oct low-pass filter
Waveforms	Sawtooth, Triangle, Square, Pulse
Controls	Modulation Wheel
LFO	No dedicated LFO; Oscillator 3 can be used as an LFO