Moog Minimoog Tuning Procedure

SCALE
OSCx=OSC1, OSC2, or OSC3
27) Turn on OSCx in the mixer on the front panel.
All other switches in the mixer should be OFF.
28) Change OSCx RANGE switch on the front panel to 16.
29) Hold down the LOW A key and adjust OSCx SHIFT trimpot for 55hz.
30) Hold down the HIGH A key and adjust OSCx SCALE trimpot for 440hz.
31) Repeat steps 29 and 30 until no further adjustment is necessary.
repeat for each oscillator
HI END
OSCx=OSC1, OSC2, or OSC3
32) Turn on OSCx in the mixer on the front panel.
All other switches in the mixer should be OFF.
33) Change OSCx RANGE switch on the front panel to 2.
34) Hold down the LOW A key and adjust OSCx SHIFT trimpot for 440hz.
35) Hold down the HIGH A key and adjust OSCx HI END trimpot for 3520hz.
36) Repeat steps 34 and 35 until no further adjustment is necessary.
repeat for each oscillator
37) Repeat SCALE (steps 27-31) and HI END sections (steps 32-36) until no further
adjustment is necessary.
OCTAVE
OSCx=OSC1, OSC2, or OSC3
38) Turn on OSCx in the mixer on the front panel.
All other switches in the mixer should be OFF.
39) Change OSCx RANGE switch on the front panel to 32.
40) Hold down the HIGH A key and adjust OSCx SHIFT trimpot for 220hz.
41) Change OSCx RANGE switch on the front panel to 2.
42) Hold down the HIGH A key and adjust OSCx OCTAVE trimpot for 3520hz.
43) Repeat steps 39 through 42 until no further adjustment is necessary.
repeat for each oscillator

Moog Minimoog Specifications

General

Keyboard	44-note
Polyphony	Monophonic
Year Released	1970
Type	Analog
Oscillators	3
Filter	24 dB/oct low-pass filter
Waveforms	Sawtooth, Triangle, Square, Pulse
Controls	Modulation Wheel
LFO	No dedicated LFO; Oscillator 3 can be used as an LFO