2022-09-07 - 10 - 2200700
Touching these two areas repeatedly will allow you to display two of your desired
display parameters from these choices: coolant temperature, water depth, battery
voltage, water temperature, oil pressure, clock and engine hours.
Displays the depth from the bottom of the boat’s hull to the floor of the water source.
The Amplitude Presets are used in conjunction with the AutoWake system to achieve
the optimal surf number and wave size. Select between 0%, 50% or 100% Amplitude.
When AutoWake is turned off, touching this area will display the ballast screen where
you can adjust each ballast individually or drain/stop/fill all ballasts at the same time.
To Next Page
