2022-09-07 - 37 - 2200700
leak in the system. Your local dealer can help you adjust this setting if you continue to have
popups but you have confirmed you do not have a leak.
Ballast Autofill happens when the ballast turns on the Autofill feature after the sensor determines
the current ballast level is below a trigger margin. The system will give a popup every time Autofill
comes on. If the driver does not like Autofill, then you can disable this feature here.
Paddlewheel Fault will take the current J1939 Engine Speed at the time of a fault detection, find
80% of current engine speed, and then swap from MPH Vessel speed cruise to RPM based
cruise. If a puck is not present and the paddlewheel is used instead, this feature can detect a fault
with the paddlewheel, then switch from MPH cruise (which uses Paddlewheel) to RPM Cruise, so
that the boat doesn't change speeds (or increase speed) unpredictably.
Auto Bilge Popup notifies that the auto bilge has turned on. The ability to turn this off exists to
reduce the number of times it appears.
To Next Page
Loading...
