- 39 -
’
MSSTAC6 Step Motor Drive User Manual
MOONS’
www.moons.com.cn
• Read all available documentation before assembly and commissioning of this product. Incorrect
handling can result in injury and damage to persons and machinery. Strictly adhere to the technical
information on the installation requirements.
• It is vital to ensure that all system components are connected to earth ground. Electrical safety is
impossible without a low-resistance earth connection.
• The MSSTAC6 contains electro statically sensitive components that can be damaged by incorrect
handling. Discharge yourself before touching the product. Avoid contact with high insulating materials
(artificial fabrics, plastic film, etc.). Place the product on a conductive surface.
• To prevent the possibility of severe damage to your health or the product, keep all covers and cabinet
doors closed during operation.
• In operation, depending on the degree of enclosure protection, the product may have bare
components that are live or have hot surfaces. Control and power cables can carry a high voltage even when
the motor is not rotating.
• Never pull out or plug in the product while the system is live. There is a danger of electric arcing and
danger to persons and contacts.
• After powering down the product, wait at least ten minutes before touching live sections of the
equipment or undoing connections (e.g., contacts, screwed connections). Capacitors can store dangerous
voltages for long periods of time after power has been switched off. To be safe, measure the contact points
with a meter before touching.
Be alert to the potential for personal injury. Follow the recommended precautions and safe operating
practices highlighted with an alert symbol. Safety notices in this manual provide important information.
Read and be familiar with these instructions before attempting installation, operation, or maintenance. The
purpose of this section is to alert users to possible safety hazards associated with this equipment and the
precautions that need to be taken to reduce the risk of personal injury and damage to the equipment.
Failure to observe these precautions could result in serious bodily injury, damage to the equipment, or
operational difficulty.
4 Drive mounting
Unit: mm
To Next Page
Loading...
Need help?
General
